Configuring Voice Ports - Paradyne 9161 User Manual

Setting Up

Configuring Voice Ports

5-24
Use the E&M (Table 5-4), FXO
configure the voice port on the voice APM in the selected slot.
Configuration Edit/Display
The Voice Port Options screen appears for Port 1 of the first slot containing a
voice APM (either FXS, FXO or E&M). The displayed fields differ, depending on
the type of voice APM in the selected slot.
For E&M Voice Ports:
Table 5-4. E&M Voice – Slot ss Port p Options (1 of 2)
Port Status
Possible Settings: Enable, Disable
Default Setting: Disable
Specifies whether the E&M voice port is in use, and can be configured and assigned to
a time slot on the T1 or DSX-1 interface in order to transmit and receive voice frequency
signals.
H
E&M Voice options do not appear if Port Status is set to Disable.
Enable – The port is active, and can be configured and assigned to a time slot.
Disable – The port is not active, cannot be configured, and does not take up a time slot.
H
No alarms or traps configured for the port will be generated.
H
Existing cross-connect assignments associated with the port will be cleared. The
message This action will clear any Cross Connections for the
Port. Are You Sure? No appears. If you select:
No – The operation is cancelled. (Pressing either the Esc or Ctrl-a key acts as a
No.)
Yes – Port status is disabled and any cross connections are cleared.
Operating Mode
Possible Settings: E&M, Transmit Only
Default Setting: E&M
Selects the operating mode for the E&M voice port.
H
Operating Mode only appears if Port Status is set to Enable.
E&M – Enables normal earth and magnetic (E&M) mode.
Transmit Only – Enables the mode used to support 4-wire private-line modems that do
not require E&M signaling.
(Table 5-5), and FXS
Voice Ports
April 1999
(Table 5-6) Voice Options to
9161-A2-GH30-40