Paradyne 9161 User Manual page 269

Table D-1. SNMP MIB to User Interface Command Cross-Reference (11 of 16)
User Interface Command
main/test/port (voice):
Start Digital Loopback
Stop Digital Loopback
Start Analog Loopback
Stop Analog Loopback
Start Line Loopback
Stop Line Loopback
Start Send DRS to T1
Stop Send DRS to T1
Start Send DRS to User
Stop Send DRS to User
Start Send Quiet to T1
Stop Send Quiet to T1
Start Send Quiet to User
Stop Send Quiet to User
main/test/port (voice):
Set Tx ABCD Bits
Set Rx ABCD Bits
Set Tip & Ring Leads
Set E-Lead State
Tx ABCD Bits
Rx ABCD Bits
Tip & Ring Leads
E-Lead State
M-Lead State
9161-A2-GH30-40
SNMP MIB Object
Set devVoiceTestType to:
digitalLoopback
digitalLoopback
analogLoopback
analogLoopback
lineLoopback
lineLoopback
networkDRSTone
networkDRSTone
userDRSTone
userDRSTone
networkQuietTone
networkQuietTone
userQuietTone
userQuietTone
Set devVoiceTestType to:
testTXBits
testRXBits
testTRLeads
testELeads
From devVoiceTestType
April 1999
SNMP Cross-Reference
With devVoiceTestAction set to:
start
stop
start
stop
start
stop
start
stop
start
stop
start
stop
start
stop
With devVoiceTestAction set to:
start and devVoiceTestArgument
specifying the ABCD bit values
start and devVoiceTestArgument
specifying the ABCD bit values
start and devVoiceTestArgument
specifying Tip and Ring values
start and devVoiceTestArgument
set to idle or active
Read:
testTXBits
testRXBits
testTRLeads
testELeads
testTRLeads
D-11