Paradyne 9161 User Manual page 140

Security
Creating a Login
"
*
Security is enabled by the configuration options Login Required for the Communication Port, and Telnet Login
Required or FTP Login Required for a Telnet/FTP Session.
6-8
4. Select and set the following configuration options, as appropriate.
To . . .
Enable IP address checking
Specify the number (between 1 and 10) of
SNMP management systems that are
authorized to send SNMP messages to the
access unit
Specify the IP address(es) that identifies
the SNMP manager(s) authorized to send
SNMP messages to the access unit
Specify the access allowed for an
authorized NMS when IP address validates
is performed
5. Press Ctrl-a to switch to the screen function key area.
6. To save changes, select Save and press Enter.
7. Select the configuration area where you want to save the changes to and
press Enter.
Save Configuration To
Customer Configuration 1/Customer Configuration 2]
When Save is complete, Command Complete appears at the bottom of the
screen.
Refer to Setting Up for SNMP Management
information about SNMP configuration options.
A login ID and password is required if security is enabled.* You can define up to
six logins (login ID/password combinations). Each login must be unique and have
a specified access level.
Procedure
To create a login:
1. Follow this menu selection sequence:
Main Menu Control
2. Press Ctrl-a to switch to the screen function key area.
3. Select New and press Enter.
4. Enter login ID, password, and security level information.
Set the configuration option . . .
NMS IP Validation to Enable.
Number of Managers to the desired
number.
NMS n IP Address to the appropriate
IP address.
Access Type to Read or Read/Write.
[Current Configuration/
in Chapter 5, Setting Up , for more
Admin Login
April 1999 9161-A2-GH30-40