Paradyne 9161 User Manual page 255

9161-A2-GH30-40
linkUp/Down
Interface Variable-Bindings
H
Synchronous
Data Ports
H
(Supported by the
media-specific
H
RS232-Like MIB.)
H
H
OCU Ports
H
(Represented by an
entry in the MIB-II
interfaces table.)
H
H
1
The DTR alarm condition will only generate a linkUp/ linkDown trap if the DTE
supports the DTR lead state (Send All Ones on Data Port Not Ready configuration
option on the Main Menu
2
The OOF and EER alarm condition will only generate a linkUp/ linkDown trap if the
EDL is enabled on that port (Embedded Data Link configuration option on the
Main Menu Configuration
3
xxxxxx is the failure code
April 1999
Possible Cause
ifIndex (RFC 1573)
ifAdminStatus
(RFC 1573)
ifOperStatus (RFC 1573)
i
fType (RFC 1573)
ifIndex (RFC 1573)
ifAdminStatus
(RFC 1573)
ifOperStatus (RFC 1573)
i
fType (RFC 1573)
Configuration Sync Data Ports branch).
Sync Data Ports branch).
SNMP Traps
H
linkDown – One or more
alarm conditions are active on
the port.
Alarm conditions include:
1
– DTR Off
1
– RTS Off
– Out of Frame (OOF) for the
Embedded Data Link
2
(EDL)
– Excessive Error Rate for
the Embedded Data Link
2
(EDL)
H
linkUp – No alarms on the
port.
H
linkDown – One or more
alarm conditions are active on
the interface.
Alarm conditions include:
– Loss of Signal
– Abnormal Station Code
– 64KCC Loop OOF
3
– DDS Net Failure
– Loss of Loop Timing
H
linkUp – No alarms on the
port.
C-3