H Maintaining Com Port Directories; Displaying Directory Numbers - Paradyne 9161 User Manual

Operation and Maintenance
10. Select the configuration area where you want to save the changes to and
Maintaining COM Port Directories

Displaying Directory Numbers

8-6
6. Follow this menu selection sequence, pressing Enter after each selection:
Configuration Edit/Display
The Alarm Options screen appears.
7. Select and set the following configuration options, as appropriate.
To . . .
Automatically initiate a call (dial out)
Retry the call if the call cannot be
completed
Specify whether to disconnect
immediately after dialing out traps, or to
allow a manual disconnect to occur. (A
connection remains until manually
disconnected.)
8. Press Ctrl-a to switch to the screen function key area.
9. To save changes, select Save and press Enter.
press Enter.
When Save is complete, Command Complete appears at the bottom of the
screen.
Two Control menu selections are dedicated to dialing a remote device for
management:
Select . . .
COM Port Call Setup
COM Port Call Directories
Use the COM Port Call Setup screen to display the telephone number of the
remote device.
Main Menu Control
Alarm
Set the configuration option . . .
Alarm & Trap Dial-Out to Enable.
H
Call Retry to Enable.
H
Dial-Out Delay Time to the desired
number of minutes.
H
Alternate Dial-Out Directory to the
desired directory.
Trap Disconnect to Enable.
To . . .
Select a phone directory and view its phone number, or
to initiate and terminate external modem connections
over the FrameSaver unit's COM port. Used for
management.
Change the phone number contained in a selected
directory when using an external modem.
COM Port Call Setup
April 1999 9161-A2-GH30-40