Paradyne 9161 User Manual page 162

Displaying System Information
7-20
Table 7-2. Health and Status Messages (3 of 5)
Message What It Indicates
Yellow at DSX ss-p A yellow alarm signal is
received on the DSX-1
interface in slot ss , port p .
DTE has detected an LOS or
OOF condition.
APM Card Failed, The NAM detects an APM
Slot ss
failure for the identified slot.
OOF(EDL), Slot ss An Out of Frame (OOF)
Port p condition is detected for the
identified slot and port.
condition occurs when any two
of five consecutive frame
synchronizing bits received
from the remote unit are
incorrect. This condition clears
when a reframe occurs.
1. Cabling problem.
2. T1 facility problem.
EER, Slot ss Port p An Excessive Error Rate
(EER) condition is detected for
the identified slot and port.
Loss of Signal, Slot ss A Loss of Signal (LOS)
Port p condition has been detected
on the identified OCU-DP
interface. An LOS is declared
when a signal has been
absent on the local loop for
more than two consecutive
seconds.
Abnormal Station An Abnormal Station Code is
Code, Slot ss Port p being received from the
network DS0 for the identified
OCU-DP interface. This
condition indicates that the
far-end DSU is disconnected
or powered-off.
1
ss represents physical slots.
April 1999
What To Do
1. Check that the DSX-1 cable
is securely attached at both
ends.
2. Check the status of the
attached equipment.
1. Check if APM is removed
1
from the slot.
2. Remove, then reinstall the
APM.
3. Contact your service
representative.
1
This
1. Check that the far end is
configured for EDL.
2. Contact your network
provider.
Contact network provider.
1
1. Check that the DSU is
powered up.
2. Check the cable.
1. Check the that the far-end
DSU is operational.
2. Check the cable to the
far-end DSU.
9161-A2-GH30-40