Setting Up To Support A Telnet Or Ftp Session - Paradyne 9161 User Manual

Setting Up to Support a Telnet or FTP Session

"
9161-A2-GH30-40
Use the Telnet/FTP Session Options screen to allow a Telnet or FTP session
through an interconnected IP network. These options also set up security for the
Telnet or FTP session (see
any one time.
Procedure
1. Set the Node IP Address, Node Subnet Mask, Default Network Destination,
and the Communication Protocol Port Link (see
selection sequence:
Configuration Edit/Display
Communication
2. Set the Telnet/FTP configuration options (see
selection sequence:
Configuration Edit/Display
3. The Telnet/FTP Session Options screen appears. Enter the desired setting in
each selected field.
4. Set the Port Use configuration option to Net Link (see
menu selection sequence:
Configuration Edit/Display
Or, set the Management Link configuration option to FDL or DDL, and set the
IP address (see Table
Configuration Edit/Display
Or, set the Embedded Data Link configuration option to Enable for the
Synchronous Data Port, and set the IP address (see
menu selection sequence:
Configuration Edit/Display
Table 5-12). Only one Telnet session can be active at
Management and
Communication Protocol
User Interface
User Interface
5-12). Follow this menu selection sequence:
Network Interface Options
Synchronous Data Port Options
April 1999
Setting Up
Table 5-14). Follow this menu
Table 5-12). Follow this menu
Telnet Session
Table 5-10). Follow this
Communication Port
Table 5-3). Follow this
5-61