Paradyne 9161 User Manual page 273

Table D-1. SNMP MIB to User Interface Command Cross-Reference (15 of 16)
User Interface Command
CONFIG
main/config/ocu:
Port Status
Port Rate
Loopback Detection
main/config/cross_connect:
DSX-1-to-Network Assignments
Network to Network Assignments
Voice Port Assignments
Sync Data Port Assignments
OCU-DP Port Assignments
Clear DSX-1 Time Slots
Clear Network Interface Time Slots
Clear Slot nn
main/config/system:
Test Timeout
Test Duration
Primary Clock Source
Secondary Clock Source
main/config/user/com:
COM Port
Port Usage
Port Type
Data Rate
Character Length
Parity
Stop Bits
Ignore Control Leads
Clock Source
main/config/management/security:
IP Address
Access Type
main/config/management/trap:
IP Address
Destination
General Traps
Enterprise-Specific Traps
Link Traps
Link Traps Interfaces
9161-A2-GH30-40
SNMP MIB Object
Set/Read:
ifAdminStatus to up or down
devOcuRate
devOcuLoopbackDetection
Fully supported by the device cross-connect MIB objects using:
devDs1FracTable
devDs1FracTable
devDs1FracTable
devSyncDataPortAssignTable
devDs1FracTable
Use devDs1FracTable to clear all time slots
Use devDs1FracTable to clear all time slots
Use devDs1FracTable to clear all time slots
Set/Read:
devConfigTestTimeout
devConfigTestDuration
devConfigClockSrcTable (read only)
devConfigClockSrcTable (read only)
Set/Read:
devPortUsage to netlink , alarm , or terminal
See the Asynchronous/Synchronous Port Table for the entry
rs232PortInSpeed or rs232PortOutSpeed for the port
rs232AsyncPortBits for the port
rs232AsyncPortParity for the port
rs232AsyncPortStopBits for the port
rs232PortInFlowType for the port
rs232SyncPortClockSource to internal or external
Set/Read:
devSecurityMgrIpAddress
devSecurityMgrAccess to read or readWrite
Set/Read:
devTrapMgrIpAddress
devTrapMgrDestination
devConfigTrapEnable
devConfigTrapEnable
devConfigTrapEnable
ifLinkUpDownTrapEnable for the interface
April 1999
SNMP Cross-Reference
D-15