Configuring Ocu-Dp Ports - Paradyne 9161 User Manual

Setting Up

Configuring OCU-DP Ports

5-32
Table 5-6. FXS Voice – Slot ss Port p Options (4 of 4)
Trunk Cond in CGA
Possible Settings: Busy, Idle
Default Setting: Busy
Determines the trunk condition or state that the port is forced into as a result of the
Carrier Group Alarm (CGA).
H
Trunk Cond in CGA only appears if Port Status is set to Enable.
Busy – Forces the port to Busy during the Carrier Group Alarm.
Idle – Forces the port to Idle during the Carrier Group Alarm.
Use the OCU-DP Options (Table 5-7) to configure the ports (either two or six) on
the OCU-DP APM in the selected slot.
Configuration Edit/Display
The OCU-DP Options screen appears for Port 1 of the first slot containing an
OCU-DP APM.
Table 5-7. OCU-DP Options – Slot ss Port p Options (1 of 3)
Port Status
Possible Settings: Enable, Disable
Default Setting: Disable
Specifies whether the OCU-DP port is in use, and can be configured and used to
transmit and receive data.
H
OCU-DP options do not appear if Port Status is set to Disable.
Enable – The port is active, and can be configured used to
Disable – The port is not active, cannot be configured, and cannot transmit/receive
data.
H
No alarms or traps configured for the port will be generated.
H
Existing cross-connect assignments associated with the port will be cleared. The
message This action will clear any Cross Connections for the
Port. Are You Sure? No appears. If you select:
No – The operation is cancelled. (Pressing either the Esc or Ctrl-a key acts as a
No.)
Yes – Port status is disabled and any cross connections are cleared.
OCU-DP Ports
April 1999 9161-A2-GH30-40