H Controlling Snmp Access; Disabling Snmp Access - Paradyne 9161 User Manual

Controlling SNMP Access

Disabling SNMP Access

"
9161-A2-GH30-40
See Limiting Asynchronous Terminal Direct Access
limit access to the dial-in session.
Setting Up the Communication Port to Support an External Device
Refer to
Chapter 5, Setting Up , for more information.
The T1 access unit supports SNMP Version 1, which only provides limited
security through the use of community names. There are three methods for
limiting SNMP access:
H
Disabling SNMP access.
H
Assigning SNMP community names and access levels.
H
Assigning IP addresses of NMSs that can access the unit.
The General SNMP Options screen provides the configuration option to disable
SNMP access to the unit. When this configuration option is disabled, the access
unit will not respond to any SNMP messages and will not send SNMP traps.
Procedure
To disable SNMP access:
1. Follow this menu selection sequence:
Main Menu Configuration
2. Select the desired configuration area and press Enter.
Load Configuration From
Customer Configuration 1/Customer Configuration 2]
3. Follow this menu selection sequence, pressing Enter after each selection:
Configuration Edit/Display
Communication
The General SNMP Management Options screen appears.
4. Set the SNMP Management configuration option to Disable; Disable is the
factory default setting.
5. Press Ctrl-a to switch to the screen function key area.
6. To save changes, select Save and press Enter.
7. Select the configuration area where you want to save the changes to and
press Enter.
Save Configuration To
Customer Configuration 1/Customer Configuration 2]
When Save is complete, Command Complete appears at the bottom of the
screen.
[Current Configuration/
Management and
General SNMP Management
[Current Configuration/
April 1999
Security
on page 6-1 if you want to
in
6-5