Table of Contents
Advertisement
14. Connect all peripheral cables to the server.
15. Connect each power cord to the server.
16. Connect each power cord to the power source.
17. Power up the server on page 23.
The installation is complete.
Installing the serial port option
Prerequisites
Before you perform this procedure, make sure that you have the following items available:
•
Serial port option
•
T-15 Torx screwdriver
Procedure
1.
Power down the server on page 23.
2.
Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3.
Disconnect all peripheral cables from the server.
4.
Do one of the following:
•
Server in rack mode: Remove the server from the rack on page 23.
•
Server in tower mode: Position the tower server for hardware configuration on page 25.
5.
Remove the access panel on page 25.
6.
Remove the PCI air baffle on page 29.
7.
Remove the system air baffle on page 30.
8.
Open the PCIe slot cover retainer and remove the serial port slot blank.
Hardware options installation
91
Advertisement
Table of Contents
