Table of Contents
Advertisement
If the server is in tower mode: Position the tower server for hardware configuration.
•
If the server is in rack mode: Remove the server from the rack.
•
5.
Remove the front bezel.
6.
Remove the access panel.
7.
If installed, remove the air baffle.
8.
Open the DIMM slot latches.
9.
Align the notch on the bottom edge of the DIMM with the keyed surface of the DIMM slot, and then fully press the
DIMM into the slot until the latches snap back into place.
The DIMM slots are structured to ensure proper installation. If you try to insert a DIMM but it does not fit easily into
the slot, you might have positioned it incorrectly. Reverse the orientation of the DIMM and insert it again.
10. If removed, install the air baffle.
11. Install the access panel.
12. Install the front bezel.
13. Connect all peripheral cables to the server.
14. Connect the power cords:
a. Connect each power cord to the server.
b. Connect each power cord to the power source.
15. Power up the server.
The installation is complete.
After installing the DIMMs, use the System Utilities > System Configuration > BIOS/Platform > Configuration (RBSU)
> Memory Options to configure the memory settings.
M.2 SSD/dedicated iLO/serial port enablement option
This option provides support for the following:
Hardware options installation
69
Advertisement
Table of Contents
