Table of Contents
Advertisement
Programming
Operating Instructions D669 M-TYPE DELTA - 00.0 - 10/2020
5.7.2
Canceling a program in Automatic mode
To cancel a program in Automatic mode:
1.
Push the pedal fully back.
The program is canceled and the thread cut. The machine
takes note of where the program was canceled, and then
continues from the same point when sewing resumes.
2.
To cancel the program completely, press the pedal all the way
backwards again.
The program is canceled, and the machine starts from the
first seam section in the program when sewing resumes.
Important
Canceling by pedal is only possible if the parameter segment
switch by pedal is NOT active in the program defaults at the
Technician level.
If the parameter is still active, you can cancel the program only
by pressing the cross on the control panel.
99
Advertisement
Table of Contents
