Setting Cross-Segment Parameters - Dürkopp Adler D669 Operating Instructions Manual

Icon Parameter
Additional values (+)
Additional value stitch
length (+)
The 2
switched on using a button on the push
button panel or the tile on the control
panel.
Additional value sewing foot
stroke (+)
The 2
can be switched on using a button on
the push button panel, the knee button or
the tile on the control panel.
Additional value needle thread
tension (+)
The 2
tension can be switched on using a
button on the push button panel or the tile
on the control panel.
Gap (2
The 2
motor driven edge guide and the needle
(factoring in the defined safety distance to
the sewing feet).
Main Parameter
Bobbin monitor mode
74
5.6.3

Setting cross-segment parameters

There are various options for setting the cross-segment
parameters. The following table lists all possible options.
Settings that are more complex and therefore require further
explanation are described in more detail after the table.
nd
value for the stitch length can be
nd
value for the sewing foot stroke
nd
value for the needle thread
nd
value)
nd
value for the gap between the
Operating Instructions D669 M-TYPE DELTA - 00.0 - 10/2020
Programming
Setting
Value range
00.0 - 12.0
(depending on sewing equipment
and subclass)
Value range
05.0 - 09.0 [mm]
Value range
01 - 99
Value range
1.0 - 45.0
(depends on the sewing
equipment)
(see  p. 77)