Setting Cross-Segment Parameters - Dürkopp Adler D887 e-con Operating Instructions Manual

Programming Commander DELTA
Icon Parameter
Additional values (+)
Additional value stitch length (+)
The second value for the stitch length can
be switched on using the button on the
push button panel or the tile on the con-
trol panel.
Additional value needle thread tension (+)
The second value for the needle thread
tension can be switched on using the but-
tons on the push button panel or the tile
on the control panel.
Additional value of top fullness (+)
The second value for the top fullness can
be switched on using the button on the
push button panel, with the knee button or
with the button on the control panel.
Additional value of bottom fullness (+)
The second value for the bottom fullness
can be switched on using a button on the
push button panel, with the knee button
or with the button on the control panel
Gap (second value)
Second value for the gap of the motor-
driven edge guide to the needle (consid-
ering to the defined safety clearance to
the sewing feet).
Main Parameter
Needle cooling
Activate needle cooling
Operating Instructions D887 e-con - 00.0 - 11/2023
5.7.3

Setting cross-segment parameters

There are various options for setting the cross-segment parame-
ters. The following table lists all possible options.
Settings that are more complex and therefore require further
explanation are described in more detail after the table.
Settings
Value range
00.0 – 12.0 [mm]
(depending on sewing equipment
and subclass)
Value range
01 – 99 [%]
Value range
-06 – 16
Value range
-06 – 16
Value range
08.0 – 45.0 [mm]
(depends on the sewing
equipment)
Value range
On/Off
101