Table of Contents
Advertisement
Programming Commander DELTA
Icon
Parameter
Additional values (+)
Additional value stitch
length (+)
The 2
be switched on using a button on the
push button panel or the tile on the
control panel.
Additional value sewing foot
stroke (+)
The 2
can be switched on using a button on the
push button panel, the knee button or the
tile on the control panel.
Additional value needle thread
tension (+)
The 2
sion can be switched on using a button
on the push button panel or the tile on the
control panel.
Gap (2
The 2
motor driven edge guide and the needle
(factoring in the defined safety distance to
the sewing feet).
Main Parameter
Bobbin monitor mode
Point position
The distance of the needle from the mate-
rial can be adjusted to allow precise
positioning of the sewing material when
starting sewing. The value entered here
corresponds to the degree number on the
handwheel.
Operating Instructions D869 e-con - 00.0 - 06/2023
5.6.3
Setting cross-segment parameters
There are various options for setting the cross-segment parame-
ters. The following table lists all possible options.
Settings that are more complex and therefore require further
explanation are described in more detail after the table.
nd
value for the stitch length can
nd
value for the sewing foot stroke
nd
value for the needle thread ten-
nd
value)
nd
value for the gap between the
Setting
Value range
00.0 - 12.0
(depending on sewing equipment
and subclass)
Value range
05.0 - 09.0 [mm]
Value range
01 - 99
Value range
1.0 - 45.0
(depends on the sewing
equipment)
(see p. 84)
Value range
000 – 359 [°]
81
Advertisement
Table of Contents
