Removing The System Board Assembly - HPE ProLiant MicroServer Gen10 Plus v2 User Manual

7. Remove the chassis cover:
a. Remove the cover thumbscrews.
If the thumbscrews are too tight, use a T-15 Torx screwdriver to remove them (callout 1).
b. Slide the cover about half an inch towards the rear panel until the arrowhead markers on the front edge of the chassis are exposed,
and then detach the cover from the server (callout 2).

Removing the system board assembly

Removing the system board assembly
Prerequisites Prerequisites
Before you perform this procedure, make sure that you have a T-15 Torx screwdriver available.
About this task About this task
To access most internal components, remove the system board assembly.
Procedure Procedure
HPE ProLiant MicroServer Gen10 Plus v2 User Guide 31