Table of Contents
Advertisement
Detach the other end of the cable from the adhesive pad.
2.
Replacing the system board assembly
Process overview:
Prepare the server for hardware replacement (on page 20).
1.
Remove the solid-state device (on page 39).
2.
Remove the access panel (on page 23).
3.
If installed, remove the communication board (on page 23).
4.
Remove the server drive assemblies (on page 25).
5.
Remove the middle frame (on page 26).
6.
Remove all DIMMs
7.
Remove the ambient temperature sensor cable (on page 46).
8.
Remove the drive SATA-power Y-cables
9.
Remove the fan
10.
Remove the system board assembly.
11.
Install the system board assembly (on page 48).
12.
Connect all cables disconnected from the failed system board.
13.
Install all components removed from the failed system board.
14.
Prepare the server for operation (on page 28).
15.
Re-enter the server serial number and the product ID
16.
product
ID" on page 49).
Remove the system board assembly
Before you perform this procedure, make sure that you have a T-15 Torx screwdriver available.
("Remove the
DIMM" on page 40).
("Remove the server
fan" on page 43).
("Remove the drive SATA-power
("Re-entering the server serial number and
Removal and replacement procedures 47
Y-cable" on page 42).
Advertisement
Table of Contents
