Removing And Replacing The Intrusion Detection Switch - HPE ProLiant DL360 Maintenance And Service Manual

Removing and replacing the intrusion detection switch

Removing and replacing the intrusion detection switch
Procedure Procedure
1. Power down the server.
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Do one of the following:
a. Extend the server from the rack .
b. Remove the server from the rack .
4. Remove the access panel .
5. Disconnect the cable and remove the switch.
To replace the component, reverse the removal procedure.
Removing and replacing the intrusion detection switch 142