Verifying Communications Between The 9025Tr And The Keykode Reader; Figure 2-23: Cable To Connect 9025Tr To 5500 Keykode Reader - evertz 9025TR Series Instruction Manual

baud rate to 9600 baud, set system parameter Class 25, parameter number 32 to a non-zero value. See
Chapter 4 for more information on setting the 9025TR system parameters.

Figure 2-23: Cable to Connect 9025TR to 5500 KeyKode Reader

2.15.3. Verifying Communications between the 9025TR and the KeyKode Reader

Once the KeyKode reader head has been installed on the telecine, and the 5550 KeyKode decoder is
connected properly to the 9025TR, you are ready to verify that the reader is reading properly, and that the
two units are communicating.
Put a piece of bar-coded film stock onto the telecine, and put the telecine in Play. You should observe
that the reader unit is reading the KeyKode, as by the KeyKode LED on the 5550 Decoder unit. If the KK
BEEP menu item on the 5550 is set to ON, a tone from the 5550 also indicates that it is reading
successfully. The KK LED on the KeyLog TRACKER™ screen should blink On each time a barcode data
record is sent to the 9025TR.
Once you have verified proper communications, proceed to the system calibration procedure in chapter 3.
After you verify the basic system timing without KeyKode you will be ready to learn the head offset
parameters for each film gauge and transfer rate.
installation procedure for the reader unit and connections to the 9025TR as outlined in the previous
sections.
INSTALLATION
9025TR End
9 pin D Pin
Male
TxD 2
RxD 3
Sig Gnd 5
Frame Gnd Shield
9025TR Series Film Footage Encoders Manual
KeyKode Reader
Belden Pin
9501
Red 2
drain 5
Shield
If communications are not realised, check the
Revision 1.3
End
9 pin D
Male
RxD
TxD
Sig Gnd
Frame Gnd
Page 2-31