Ericsson ZAT 19.2 Operation Manual page 98

Table of Contents

Advertisement

3.5
Result codes
As shown above the Result Codes may be displayed in short or
verbal form. The result codes in verbal format may display
CONNECT 12009. In short form the result code CONNECT 1200
changes to 5
Result cod
OK
0} Execution of an approved command string.
CONNECT
1} A connection has been established at 0 - 300
bit/s, or the XO command is active.
RING
2| Ring signal is detected.
NO CARRIER
3] Failure to connect or loss of carrier.
ERROR
4| Command nol recognized.
Too long command
string. (More than 80 characters).
CONNECT 1200
5| A connection has been established at 1200 bps.
NO DIALTONE
6} The W command is issued,and dial tone is not
detected within the period specified by S7. The
X2 or the X4 command is issued, and the dial tone
is not detected within 5 seconds after off-hook.
BUSY
7| Busy signal detected.
NO ANSWER
8] Calling the Paging System and no receipt tone
detected after use of the % dial modifier. 5
seconds silence not detected after use of the @
dial modifier.
CONNECT 0600
9| A connection has been established at 600 bps.
CONNECT 2400
10| A connection has been established at 2400 bps
CONNECT 4800
11] A connection has been established at 4800 bps
CONNECT 9600
12] A connection has been established at 9600 bps
CONNECT 7200
13| A connection has been established at 7200 bps.
CONNECT 12000
14| A connection has been established at 12000 bps.
CONNECT 14400
15| A connection has been established at 14400 bps.
CONNECT 76800
16} A connection has been established at 16800 bps.
CONNECT 19200
17| A connection has been established at 19200 bps.
CONNECT/REL
20| MNP/LAPM
in 300 bps
CONNECT 0600/REL
21| MNP/LAPM in 600 bps
CONNECT 1200/REL
22} MNP/LAPM in 1200 bps
CONNECT 2400/REL
23
I Speed Comecion est)
and +Q1 are used
simultaneously. The Result code CONNECT
wOOREL/yyy displays (xxxx= baudrate towards
the remote modem)
(yyyy= baudrate towards the DTE.
CONNECT 4800/REL
24| MNP/LAPM tn 4800 bps
CONNECT 9600/REL
25|MNP/LAPM in 9600 bps
(CONNECT
Using+Q2 or +Q3 (extra resultcodes)
9600/REL/9600/TCM)
and TCM handshake.
CONNECT
7200/REL
26 | MNP/LAPM
in 7200 bps
CONNECT
27| MNP/LAPM in 12000 bps
12000/REL
3-60
1ZTR104006 R1.00
ZAT 14.4/14.4-7 and Zat 19.2/19.2-7

Advertisement

Table of Contents
loading

This manual is also suitable for:

Zat 19.2-7Zat 14.4Zat 14.4-7

Table of Contents