Ericsson ZAT 19.2 Operation Manual page 93

.-3. Command sets
X Dial tone/Busy detect - "Connect" messages
Commands: X0, X1, X2, X3, X4
"Blind dial" is not allowed in Sweden. therefor the commands
X0, X1, and X3 are not allowed to use in Sweden.
Some local exchanges (PABX) uses a non-standard dial tone
which the modem may not be able to detect. The X commands
may disable dial tone detect in the modem to avoid this problem.
ATX0g*| The modem reports CONNECT once a
satisfaclory connection is established. The
=| modem wails a number of seconds,
_ | determined by S6 regisler, and dials the
number regardiess of whether the dial tone is
present or not. (Blind dial). Busy signals will
not be recognised.
'ATX1 pial] The modem sends:
: CONNECT or
Be e e . CONNECT 0600 or
nae CONNECT 1200 or
CONNECT 2400 or
CONNECT4800 or
CONNECT 7200 or
CONNECT 9600 or
CONNECT 12000 or
CONNECT 14400 or
CONNECT 16800 or
CONNECT 19200
| The modem wails a number of seconds
determined by S6 register, and dials the
_Jnumber without any dialtone detection. (Blind
dial). After dialling, any busy signals will not
be recognised.
The modem sends CONNECT or CONNECT
ann. (See command X1). Modem waits for
dial tone before dialling and reports NO
DIALTONE if dial tone is nol detected within
20 seconds. (This parameter will depend on
the selected country code). After dialling, any
busy signals will nol be recognised
The modem sends CONNECT or CONNECT
nnn. (See command X1). The modem blind
dials (dials the number regardiess whether the
dial tone is present or not, but waits number of
seconds determined by S6-register) and
reports BUSY if busy signal is delected after
gids oP, dialling.
"ATY 2 The modem sends CONNECT or CONNECT
ATX4g%| ann. ©
Modem waits for dial tone, before dialling
-!Reports NO DIALTONE if dialtone is not
detected within 20 seconds. It reports BUSY if
busy signal is detected after dialling.
Associated commands: Q, +Q, V.