[3: Command sets _
&W_
Save Active Memory Configuration Profile
Commands:
&W0, &W1
This command stores the active modem configuration in one of
two userdefined memories. The active memory is lost if the
power goes down, but the two userdefined memories are intact
even during long periods without power.
Example:
(In some cases it may be necessary using
AT&D2&WOp
|
&D2 is stored in the userdefined memory
another example:
AT&F&W1p% |
&D2 and &D3 to go on hook.)
The command reinstall the factory values
into Active memory and store the
configuration in userdefined memory 1
+W Select 2-wire or 4-wire configuration
Commands: +WO0, +W1
Applies to leased line only.
AT+WOe*| Sach Select the 2 wire configuration
AT#W1
ps
_
Select the 4 wire configuration
3-54
LZTR104006 R1.00
ZAT 14.4/14.4-7 and Zat 19.2/19.2-7