Ericsson ZAT 19.2 Operation Manual page 94

&X Source Transmit Clock for Synchronous Mode
Commands: &X0, &X1, &X2
AT&X0g*s| The modem sources transmit clock
V.24 circuil 114
ee gy fos ; -
AT&X1 pte] oe - " | The dala terminal (DTE) sources transmit
clock. V.24 circuit 113
clock is used as transmil clock. V 24 circuit
115 will be both transmit and received clock.
\X Transparent XON/XOFF mode
Commands: \XO, \X1
If XON/XOFF local flow control on transmitted data to DTE (\Q1
or \Q4) is selected, this command selects whether an
XON/XOFF character received from DTE should be sent to the
remote modem.
- - - -
AT\X0 pr The modem witl nol transmit a received
XON/XOFF characler from DTE to the remote
modem.
AT\X1 e=| : .|A received XON/XOFF character received
from DTE is sent to the remote modem.
\X1 should not be used in conjunction with the \G1 or \G2
commands because the remote modem will receive XON/XOFF
from two sources: The modem (\G) and the DTE. This may lead
to a conflict.
&Y Recall user Profile on power up
Commands: &Y0, &Y1
The modem will always recall its configuration from a
userdefined profile after power up. This command selects which
profile to use:
pre al Recall userdefined profile 0 at power up. This
AT&YO fe profile is stored by &WO.
: v4 pines _,. Recall userdefined profile 1 al power up.
AT& 'Vee al This profile is stored by &W11
3-56
LZTR104006 R1.00
ZAT 14.4/14.4-7 and Zat 19.2/19.2-7