Table of Contents
Advertisement
+S7
Bit mapped options*
Binary code: xxx9 xxxx Default: 03 hex
Bit 1,0 | Automatic Speed
00}(+M0)
| Speed detect off
detection
01)(+M1)
| Speed detect only in
Answer mode.
(See +M command)
101(+M3)
| Speed limit
11}(+M2) | Speed detect in answer and
call mode.
Bit2
| Service Provider
0
Public network
1
Private network
Bit3
| Result codes
0|(Q0)/
| Result codes defined by
in answer mode
(Q1)
$14 bit 2
(See Q command)
1] (Q2)
No result codes in
answer mode.
Bit4
| On-line data format
0|(+&GO) | Enabled
(See +&G command)|
1 ] (+&G1) | Line format is locked to
+S6
BitS | 108.1 mode
O}(+E0)
| Inactive
(See +E command)
1|(+E1)
| Active.
Bit 6,7 | Half/full duplex
O)}(+HO) = | Full duplex
(See +H command)
1/(+H1)
| Full duplex with back-channel,
V.23
Not used, reserved
(+H3)
Full duplex 4-wire leased
line,
V.23
+S8
= Inactivity timer
Default
30 (300 sec). Unit : 10 sec.
Range:
1-255
The modem will disconnect if no line activity is detected for a
period set by +S8.
This function ts available only in asynchronous on-line mode.
Result Code NO CARRIER will be given when modem
disconnects.
The inactivity function may be active on either receive or
transmit data or both. (See +&T and &DB command).
*Read more about country dependent parameters in appendix 5.
Zat 14.4/14.4-7 and 19.2/19.2-7
Advertisement
Table of Contents
