Table of Contents
Advertisement
5. Manual operation
5.5.2
Example describing manual connection as calling
modem:
Assume that the modem
is setup as in example above. You
want to connect to a database (e.g. SEMAFORUM with phone
no. Norway 37011710) Call this number and wait until you hear
the answer tone (A high frequency tone with duration
approximately 3 seconds. ).
When you hear this tone press ROLL/EXEC with the cursor in
the CALL position or press the VOICE/DATA switch with
modem setup in calling(originate) mode.
The modem will now establish a connection, and you may
communicate using your terminal. If you want to disconnect then
select the disconnect menu at the database. The database
modem will then disconnect and your modem will disconnect
when loss of carrier is detected.
If you want the modem to dial a number when the switch is
pressed, this can be setup in SETUP menu or by the AT
command +&VD1.
5-8
LZTR104006 R1.00
Zat 14.4/14.4-7 and Zat 19.2/19.2-7
Advertisement
Table of Contents
