Ericsson ZAT 19.2 Operation Manual page 161

Should any S-registers be changed or displayed
ige S/+S registe
a _ Beane Fas S register :
You may edit upper display line as following: Move
cursor lo nn position to select register. (Use
CURS switch). Then press the ROLL/EXEC switch
to change The register number. The register will
increment by one each time this switch is pressed,
and the registered value (xxx will be displayed) To
change the registered value move Ihe cursor to
xxx (following "=") and press the ROLL/EXEC
switch for each digit which should be changed the
new value will not be stored in the active S
register position before SET Command has been
executed. (Move the cursor to the SET position
and then press the ROLL/EXEC switch.)
STAND-S- Toggle between Standard Hayes S register and
REG/PLUS- +S register. Move the cursor to this position and
S-Reg press the ROLL/EXEC switch.
DEC/HEX Toggle between decimal and hex presentation of
register value.
SET Store the selected value (xxxx) in the active
configuration. The S-Register will not take a new
value until this command ha been executed.
FACTORY Restore the factory (default) value associated with
the current (displayed) register. The value will nol
be stored in the active configuration. Untit SET
has been executed.
EXIT Exit this menu.
LZTR104006 R1.00
Zat 14.4/14.4-7 and Zat 19.2/19.2-7