In Switched Line this function can be set up by the +E0
command or from front under SETUP menu. The modem will not
take any action until a command is given, an incoming call is
detected or a switch is pressed at the front of modem.
In Leased Line the 108.2 function does not exist. (The modem
may be set up to 108.1 or "Always on".)
Associated commands and registers:
"ss.
1108.1 in leased line.
The 105 (RTS=Request to send) Circuit
in command mode this circuit will have no consequence.
In Data mode this circuit may control the 106 (CTS) circuit. This
function is set up by the &RO command, or from front under the
SETUP menu. The 106 circuit will follow the 105 circuit. When
the modem detects an OFF to ON transition on 105, 106 will turn
ON after a delay determined by register S26. The time base for
this register is 10 msec. and it may be set up by AT command or
from front under SETUP menu.
When modem detects an ON to OFF transition on 105, 106 will
turn OFF.
"Note.
This function is not active during any loop tests.
LZTR104006 Rt.00
12-13
Zat 14.4/14.4-7 and 19.2/19.2-7