Ericsson ZAT 19.2 Operation Manual page 87

__3. Command sets -
a
\S_ View modem configuration
Commands: \SO, \S1
AT\SOg@= | b s : Displays all commands with text info.
ATIS1 p i ]
=| Displays all commands that is different from
| factory setting.
+S Extra S-Registers (Semafor Registers)
The modem has an extended set of S registers in addition to the
AT standard registers. These registers are assigned or displayed
with the following commands:
+Sn=x Assign register n the value x (x on decimal notation)
+Sn=Hx Assign register n the value x (x on hex notation)
+Sn=Bx Assign register n the value x (x on binary notation)
+Sn? Display the value of register n on decimat notation
+SnH? Display the value of register n on hex notation
+SnB? Display the value of register n on binary notation
+&S Controls 111/112 function
Commands : +&S0, +&$1, +&S2, +&S3
AT+&S0g%) - 111 function is disabled
f s "1111 controls low/high rate within standard
| selected wilh +&M.
112 controls low/high rate within standard
- | selecled with +&M.
Combining +&S1 and +&S2, both 111/112
functions are active
"The Jumper field J10 may need to be changed. Default
setup of Jumper field J10 is 111 on pin. 23 and 112 on
pin. 12.
See chapter 5 for more detailed information of jumper
field J10
The V.24 ciruit 112 will not indicate the speed if the modem is
setup for +&M2/V.22. The +&M2 command should only be used
for speed selection (111).
LZTR104006 R1.00 3-49
ZAT 14.4114.4-7 and Zat 19.2/19.2-7