Ericsson ZAT 19.2 Operation Manual page 181

assword/dialback -
6.3. The Password Table
The modem can store 7 Kbytes in the password table. The maximum
number of passwords that can be stored is dependent on the length
of the individual password entries in the list. When a new password is
entered and the storage space is to small for the new entry , the
modem will respond :
NO MORE SPACE AVAILABLE
All passwords in the table have to be specific. If a new password is
entered into the table and it already exists, the modem responds:
PASSWORD EXISTS
If the password table is empty and a request for a listing of
passwords stored is entered , the modem will respond :
PASSWORD TABLE IS EMPTY
Trying to list out a specific password not stored will cause the
following response :
PASSWORD NOT FOUND
6.4 Definitions
A password stored in the password table is defined as follows :
<password>:<telephonenumber>:<access-level>:<crypt(k} or auto legin{a ©
6.4.1 Separators
(ASCII 58 Dec) is used as a separator between the fields.
may also be used as a Separator between the password and the
telephone number.
6.4.2 <password>
This record is mandatory in all entries and is used for access
acceptance check and as a link to the telephone number to be
used for dialback.
e Any characters with ASCII codes lower than 21H will be
removed from the string.
e Lower case characters are converted to uppercase.
e The length of this entry is minimum 4, maximum 10
characters. Violating these rules when entering a password
into the table will cause the modem to respond with the
ERROR message.