Ericsson ZAT 19.2 Operation Manual page 77

+PG___—~Profile Guarding
Commands: +PG0, +PG1, +PG2, +PG3, +PG4, +PG5,
+PG6, +PG7, +PG8.
Profile Guarding is intended for use in Network systems and
when it is essential that the modem configuration is constant.
When executing the +PG command the modem will read the
parameter used for &Y command (profile to use after power up)
and write the current S register set to the power up profile.
AT+PCOgA
No Profile Guarding or Restriction in
Commands. Note that +PGO must be used to
turn off profile guarding. The command to set
factory configuration will not turn off profile
guarding
" 1 Disable the following commands: &W, &Y, &Z
and give ERROR result code when these
=| commands are executed. The &W command
ts protected only for the power up profile. The
power up profile is reloaded during
| disconnect.
As +PG1, bul OK result code when the
commands, &W, &Y, &Z are executed. The
power up profile is reloaded during
disconnect.
"=! Commands in the exception list are protected,
ERROR result code is displayed for these
- { commands.
-{As +PG3, but OK result code is displayed for
the commands in the exceplion list.
Accept commands specified in the exception
list only. ERROR result code is displayed for
all other commands.
As for +PGS5, but OK result code is displayed
{for illegal commands (those nol in the
exception list).
| Commands in the exception list are free to
--puse, all olhers are protected by the +PA
|} command.
" | Commands in the exception list are protected
by the +PA command. All the others are free
to use.
LZTR104006 R1.00
3-39
Zat 14.4/14.4-7 and Zat 19.2/19.2-7