Ericsson ZAT 19.2 Operation Manual page 72

+N National adaptations and Product information
Command: +N
This command displays which country and which transmit level
the modem hardware is strapped to, and which firmware version
the modem uses.
AT+Ne|) - |
"Typical response: | Zat 19.2/19.2-7 Zat 14.4/14.4-7
Product: Zat 19.2/19.2-7 Zat 14.4/14.4-7
SW name: RYSR 092000 S/X_|RYSR 092000 S/x
Ver/Date ROS.093 27/06-93 09.093 27/06-94
Country: NORWAY NORWAY
Switched line Xmit level } -10dBm -10dBm
Leased line Xmil level |-10dBm -10dBm
PCB 31* 3.1
Data Pump AT&T HSM1900 AT&T HSM13900
DSP code revision 65 6.5
This information is subject for change.
"The first digit is the PCB revision. The last digit is the
PBA.
O Return to On-line State
Commands: 00, 01, 02, 03
The command is used if the modem has previously returned
from on-line state to command state by issuing the escape
sequence (+++) or by a DTR ON to OFF transition.
Causes the modem to return to on-line state
Also: If no connection is made the modem will
start a new handshake
Returns the modem to the on-line state and
iniliates a new training sequence. May be
issued if the bil error rate is too high. The
command applies to V.22 bis, V.32 and V.32
bis only.
Fallback. The modem will start a training
sequence with fallback within the current
modem slandard. This applies to V.32 and
V.32 bis only. Speed conversion (+C1) should
be enabled at both modems to maintain the
. -[OTE speed
: : Fallforward. The modem will start a training
sequence with fallfonward within the current
- modem standard. This applies to V.32 and
"|V.32 bis only. Speed conversion (+C1) should
be enabled at both madems to maintain the
DTE speed