Setting The Lerminal Oe - Ericsson ZAT 19.2 Operation Manual

2.3.2 Setting the terminal
If you have a standard data terminal, this must be set up for data
communication. The following settings must be made:
e speed 9600 bps (or 19200 bps)
e character format: 8 bits, no parity, one stop bit
e Output to the serial port to which the modem is connected
e full duplex
Asynchronous communication
Some terminals contain the option of selecting various terminal
types. It may be difficult to select that type which is best suited to
Semaforum BBS. The best procedure is to set the terminal as a
«standard ANSI terminal». Should this selection not be given on
your equipment, you can set it to «TTY». This signifies that the
terminal will function as a non-screen-based terminal (non-CRT).
e Use the communications port normally used to connect the
modem (normally COM 1)
¢ Transfer speed 9600 or 19200 bps
e Character format: 8 bits, no parity, one stop bit
e Full duplex
e Asynchronous communication
2-3
Zat 14.4/14.4-7 and Zat 19.2/19.2-7