Table of Contents
Advertisement
cegist
S22
Bit mapped options*
Binary code: Oxxx xx00
Default: 74 hex
Bit 1,0 | Not used
Bit 3,2 | Speaker On/Off
(See M-command)
00
01
10
11
Speaker Off
Speaker on until carrier detect
Speaker always on
Speaker on until carrier detect,
Off during dial
Bit
Dial tone detect-
6.5.4
|"Connect" messages
(See X-command)
000
100
101
110
111
(X41)
(X2)
(X3)
(x4)
The modem reports once a
satisfactory connection is
established. The modem waits
a number of seconds (S6
register), and dials the number
regardless of whether the dial
tone is present or not. Busy
signals will not be recognised
The modem sends:
CONNECT
or
CONNECT 1200
or
CONNECT 2400
or
CONNECT 4800
or
CONNECT 7200
or
CONNECT 9600
or
CONNECT 12000
or
CONNECT 14400
or
CONNECT 16800
or
CONNECT 19200
or
Waits a number of seconds
(S6 ). Dials the number,
regardless of any dialtone
detection. After dialling, any
busy signals will not be
recognised.
Sends CONNECT or
CONNECT nnn. (See X1),
wails for dialtone before
dialling. Reports NO DIAL-
TONE if dial tone is not detect-
ed within 20 seconds. (Country
dependent). After dialling, any
busy signals will nol be
recognised.
Sends CONNECT or
CONNECT non. (Command
1), blind dials
but waits
number of seconds ($6) and
reports BUSY if busy signal is
detected after dialling.
Sends CONNECT
or
CONNECT ann, wails for dial
lone, before dialling. Reports
NO DIALTONE if dial tone is
not detected within 20 seconds.
Reports BUSY if busy signal is
detected after dialling.
Bit 7
|Not used
(&PO
(&P1
39/61 Puls.
33/67 Imp
4-10
Read more aboul counlry dependent parameters in appendix 5,
LZTR104006 R1.00
Zat 14.4/14.4-7 and 19.2/19.2-7
Advertisement
Table of Contents
