7.5
Synchronous Configuration
This section assumes that you are familiar with the asynchronous
encryption mode of operation.
"Synchronous encryption modules must be installed in the
modems before they are able to operate in synchronous
encrypted mode.
The power up menu will display CRYPT OK if an encryption module
is found. In addition the modem should have a software version 7.10
or higher. The modem configuration for synchronous encryption
mode is the same as for asynchronous encryption mode except that
the modem is set to synchronous mode. (&M command or by display
setting). Most synchronous applications use dumb mode as well.
Detection of escape code is not supported in synchronous mode with
encryption.
7.5.1
Switched line (automatic dial):
Assuming the modems are configured from an asynchronous
DTE at 9600 bps:
Originating modem:
= Enter password entry with encryption
AT+P=MODEN2Z: :T37024563:0:K:PASS01
23 e%|
=Enter 2 secret and random keys
0=7CB8D036A8925FA1 pil
1=9AB573FCOS3ADFB8¢%) ©
=Set fi xed encryption
= Store tel. number to remote
AT&Z0=137024563¢0|
=Set Voice/Data dialling
AT+&VD1 pla] ~
=Set synchronous mode
AT&M1 p=]
|
=Make CT-106 go off during handshake
AT&S2g%|
|
= Set dumb mode and store configuration
AT+PN13Weta|