Ericsson ZAT 19.2 Operation Manual page 143

5.5 Manual connect using the front panel switches
A manual connection may be established both in originate and
answer mode. Move the cursor to the CALL or ANS position by using
the CURS switch and then press the ROLL/EXEC when the
connection is to start. CALL will start a connection in originate mode.
ANS will start a connection in answer mode. The active configuration
will be used when these switches are used.
A manual connection may also be established by pressing the
VOICE/DATA switch. Which channel to use must be setup in the
SETUP menu or by the AT command +&VC and +&FC.
5.5.1 Example describing manual connection as answering
modem:
The modem is setup to manual (DUMB) asynchronous mode,
speed equal to 9600 bps., and 8N1 character format. First
answer the call using the telephone set. The calling person
wants to establish a modem connection.
=>Press CURS to move the cursor to the ANS (Answer) position
=>Press the ROLL/EXEC switch, the modem will take the
telephone line and start a handshake towards remote modem.
The figure below will describe the procedure just mentioned.
COMMAND: SWITCH 192 ASYNC
_ooOoOUDO «MENU. |
SETUP. CALL ANS. TE
OOOO. SW.
Alternatively you may press the VOICE/DATA switch. In this
case the modem must be setup as answering modem.
When you have finished the communication and want to
disconnect, then move the cursor to the DISC position and press
the ROLL/EXEC switch. If the remote modem disconnects this
will be detected and your modem will disconnect automatically.
The modem will also disconnect if you press the VOICE/DATA
switch.