Ericsson ZAT 19.2 Operation Manual page 126

+819 Bit mapped options
Binary code: xxAx xx00 Default: 50 hex
Bit 1,0 | Not used 0
Bit 2 |Line speed locking 0|(%GO) | Updated by command line
(See %G-command) prefix AT
1|(%G1) | Updated by the %B command,
or register +S6.
Bit3 |Select &D2 operation | O|(+&AQ) | Normal &D2 operalion
(See +&A-command) | 1/(+&A1) | Autoanswer with &D2 and
DTR off.
Bit 4 | Trellis coded 0}(+T0) |Disabled
modulation 1|(+T1) | Enabled
(See +T -command)
Bil5 {Command mode Q|(+PNO) | Command mode on
on/off 1|(+PN1) | Command mode off
(See +PN-command)
Bit 7, |€xtended DCD control | 00}(+U0) | CD (109) off during lests
6 (See +U-command) where DTE is not active
01}(+U1) | CD (109) on during test.
10}(+U2) |CD (109) always on
11 Not used
+S20 Bit mapped options
Binary code: 0000 Oxxx Default: 11 hex
Bit 2-0}DSR, CTS control | 000/(&S0) |DSR and CTS always on
(See &$-command) | 001}(&S1) |DSR/CTS are controlled
as in standard Hayes.
010)(&S2) |DSR off and CTS on in
command mode.
DSR and CTS are turned on at
same time as DCD.
011|(&S3) | DSR off and CTS off
in command mode.
DSR and CTS are turned on at
same time as DCD.
100|(&S4) {DSR always on,
CTS will never turn on if
RTS is off, but may be switched
off by flow control.
101 Not used
110 Not used
111 Not used
Bit 5-3] Test pattern for 000 | (+&LTO)| SPACE pattern
selftest 001 | (+&LT1)! MARK pattern
(See +&LT- 010| (+&LT2) | Alternating pallern
command) 011 | (+&LT3) | 511 pattern
1xx Illegai
746 Not used
4-22
LZTR104006 R1.00
Zat 14.4/14.4-7 and 19.2/19.2-7