Ericsson ZAT 19.2 Operation Manual page 262

12.8 Automatic logon procedure:
The password used for logon to a remote computer may be stored in
the password table in your local modem. After connection with the
remote modem this password is transmitted to the remote side
automatically.
Enter password for auto logon, in the calling modem.
AT+P=AUTOLO:37011710::A:SECRETgia|
In the remote modem the password "SECRET" is Saved:
AT+P=SECRETp*|
For a calling modem with password control, use the local password
table as a reference.
Calling modem dials tel. no. 37011710 and executes an auto 5 logon -
procedure.
12.9 V.24 operation
12.9.1 108.1/108.2-functions???
Two 108 functions exists:
108/1 Connect Data set to line
In this mode the modem is controlled by 108.1, and the modem
will connect to line and start a handshake or dial a number when
108.1 turns from OFF to ON. The modem will disconnect when
108.1 turns from ON to OFF.
In Switched Line this function can be set up by the +E1
command or from front under SETUP menu. Channel selection
and if a phone number should be dialed may also be setup,
either by writing to +S register 21 or from front under SETUP
menu. Setting synchronous mode with the &M
In Leased Line this function can be set up by writing to +S
register 23, bit 5 or from front under SETUP menu.
108/2 DTE ready (Data terminal ready)
In this mode 108 tells the modem that DTE is ready, and the
modem may establish a connection. The connection starts by
entering a command (AT, V25bis), answering an incoming call
or by pressing a switch at the front panel.
1 2-1 2 LZTR104006 R1.00
Zal 14.4/14.4-7 and 19.2/19.2-7