Table of Contents
Advertisement
x
_Registers |
+S16
Remote Escape code character
Default :
45 in the ASCII table "-".
Range:
0-255
Rules for accepting Remote Esc code is as for local Esc code
(Enter +S16=42. The Remote Escape code is now *, which is
the ASCII code 42). Values greater than 127 will disable
«Remote control».
+S17
Remote Escape guard time
Default :
50 x1/50 second
Range:
0-255
Determines the time delay (Guard Time) required immediately
before and after entering the remote escape sequence (- - -)
Also sets the entering speed of the - - - sequence, as the time
between each - must be less than the Guard Time.
ATS1
=100e%]
There must be a quiet time of 2 seconds
before and after sending remote escape
code.
+818
Password/Dialback locking function
Default :
255
Range:
1-255
129-255
+$18 will decremented by one (until the value 128 is reached)
whenever the modem hangs up because a wrong password is
entered. Locking will never occur.
128
+$18 will not be decremented when entering wrong password(s)
4-127
The register will be decremented by one (until the value zero is
reached) whenever the modem hangs up because wrong
password is entered.
0
Locking occurs. Access to host is no longer granted (This value
can not be set directly by a command).
Advertisement
Table of Contents
