Table of Contents
Advertisement
"These numbers may be accessed in V.25bis command
mode, but with numbers 1 to 20, where AT entry 0 equals
V.25bis entry 1
&Zn
Stores telephone number "n" at entry 0.
&Zx=n Stores telephone number "n" at entry "x"
&Z _ Deletes telephone number at entry 0.
&Zx=
Deletes telephone number at entry "x"
A telephone number can be inserted or erased from the table
with the &Z command. The total number of characters in the
table is limited. The modem will send the message NO MORE
SPACE AVAILABLE if a number is inserted and the table is full.
Erasing an entry returns more free space.
The modem can dial a stored number when controlled by:
e The dial command DS. (Described in the D command.)
e The V.24 signal 108.1. The 108.1 function must be enabled
(+E command) or &M2 command must be active. Read nire
about this function in chapter 5.
e The front switch ROLL/EXEC and register +521, bit 5 = 1.
Example of how to store a number in entry 0:
stored in non volatile
memory.
The modem < answers:
OK
The number string:
T:
Tone Dial
0:
Request for external dial tone
W:
Wait for dial tone
37011710: subscribers number
Example of how to store a number | in entry 12.
The modem See
OK
How to erase the number at entry 0:
AT&Z
Erases the stored number at entry 0.
Modem :
OK
|
Example of how to erase the number at entry 12:
es
ge
AT&Z1 2= pital
Erases the number al entry 12.
The modem answers
OK
3-58
LZTR104006 R1.00
ZAT 14.414.4-7 and Zat 19.2/19.2-7
Advertisement
Table of Contents
