Table of Contents
Advertisement
Co:
i
+&ED
Call progress method for 108.1
Commands:
+&EDO0, +&ED1
This parameter applies to switched-line mode only (&LO).
ve
- | Start handshake immediately, do not dial.
AT+&ED1 ete)
Use Cail-List 1 and dial number(s). 108.1 will
"always use Call-list
Example of configuration for 108.1 dialling.
«4108.1 function enabled.
--4
Use call-mode when leased line.
AT+RED4 ee)
- Use Calllist 1 when dialling,
AT#S35=0p%e|
Index to first number in the Call-list 1
AT#S36=1 po
: " { Index to last number in the Call-list 1
AT&Z0=T17000@)]
First number in Call-list (+$35=0)
AT&Z1=T17001
; el
Last number in Call-list (+S36=1)
When
the DTR signal changes from OFF to ON the modem will
dial the first. number in Call-list 1 (+S35=0):T17000. If the
modem fails to connect it will dial the next number, i.e. T17001
and so on, until the Call-list is empty. In this case T17001.
wr Chapter 11 explains the use of Call-list.
&F Fetch Factory Configuration Profile
Command:
&F
Fetches the factory configuration profile from permanent
memory (ROM) and transfer it to the active memory (RAM)
+$5 and +S6 req.: These are initiated to the speed and format
the &F command was issued at.
Password functions: It is not possible to change or disable any
function set-up by any +Pn command.
(i.e. Password dialback,
profile guarding or encryption).
Zat 14.4/14.4-7 and Zat 19.2/19.2-7
Advertisement
Table of Contents
