Table of Contents
Advertisement
5.7
Front control of Loop tests
From front panel you may start and stop all the loop tests. The loop
test can be entered under the TEST menu.
If the modem is in off line command mode the following TEST menu
may be entered:
If the modem is in data mode the following test menu may be
entered:
Test pattern means that an alternating 0/1 pattern is transmitted, and
the receiver will indicate errors if a change from this pattern is
detected. Note that "Test pattern only" only can be controlled from
front panel.
Move the cursor to the test you want to execute, and press the
ROLL/EXEC switch. The test can be terminated by another press on
the ROLL/EXEC switch.
LZTR104006 R1.00
5-1
1
Zat 14.4/14.4-7 and Zat 19.2/19.2-7
Advertisement
Table of Contents
