Table of Contents
Advertisement
+&VD
Call progress method by activating VOICE/DATA
Commands: +&VD0O, +&VD1
This parameter is only used when operating in switched-line
mode.
AT+&VD0pi|
No number dialing, start handshake
immediately.
AT+8 VD 1
pete|)
[Use Call list 1 and dial number(s). VOICE/DATA
AT
&
ae
e
|
switch and 108.1 uses Call-list 1.
"See chapter 11 "Call-lists".
Examples of diailing using Call switch.
AT+&VC1 pel]
.se' | Automalic channel choice by activating
elitgauge (PACT
cove.
Voice/Data
"Use Call-list 1 when dialling,
Index to first number in the Caill-list 1
Index to last number in the Call-list 1
e a | | | First number in Call-list (+S35=0)
|Last number in Call-list (+836=1)
When activating VOICE/DATA button the modem will dial the 1.
number in Call list 1 (+S35=0):T37017000. If modem fails to
connect it will dial the next number, i.e. T37017001 and so on,
until the Call-list is empty. In this case T37017001.
+&VT
Select test control with ct140/141
Commands:
+&VTO, +&VT1
AT+&VTOp te).
Disable loop test control
AT+&VT1 peal). [Enable loop test control
An OFF to ON transition of ct140 will start a remote Loop2 when
+&VT11 is Set.
An OFF to ON transition of ct141 will start a Loop3 when +&V7T1
is set. Ct140 and ct141 will be ignored with the setting +&VTO.
LZTR104006 R1.00
3-53
ZAT
14.4/14.4-7 and Zat 19.2/19.2-7
Advertisement
Table of Contents
