Table of Contents
Advertisement
icon
ommand sets °
&R RTS / CTS (Request To Send / Clear To Send)
Commands: &RO, &R14
The command is used in both synchronous and asynchronous
mode. If hardware flow control is selected in asynchronous
mode, CTS is used for flow control.
AT&ROG*|
ATER pf
7
{from ON to OFF. CTS will turn OFF
CTS follows RTS in data mode. If RTS switch
immediately. If RTS switch from OFF to ON,
CTS will turn ON after a delay
determined by
register S26
In data mode CTS ts on. Using this function,
flowcontrol wilh CTS and RTS can't be used
Enter \Q0, \Q1 or \1Q4
"This command will be ignored when hardware flow
control is enabled (\Q2 and
\Q3).
+R List value of all registers
Commands:
+RO, +R1, +R2, +R3
This command is used to obtain a listing of all registers and their
current values.
AT+ROgHe
AT#R1 pl
AT#R2phe
:
_ [ format.
Display all active S-registers in decimal
} Display all S-register in decimal format,
_:} except Bit mapped S registers which will be
"A
display in hex format.
- { Display all S-register in hex format.
AT+R3pi|
" 1 Display all S-registers in binary format.
3-46
LZTR104006 R1.00
ZAT 14.4/14.4-7 and Zal 19.2/19.2-7
Advertisement
Table of Contents
