Ericsson ZAT 19.2 Operation Manual page 50

(3. Command sets
— * . TT | Tr an - " |
Example:
Requesting the modem to dial stored number located at entry 0.
ATDS p=
or
ATDS=0p"|
Dial stored number at entry 12.
ATDS=1 264
@ Wait for quiet answer before dialling (Person finders/Pager).
Causes the modem to wait, for a period determined by register
S7 + 20 sec., for one or more rings followed by 5 seconds of
silence before processing the next symbol in the dial string.
% Checks acceptance tone from the paging service. If no
acknowledgement is received, the modem reports NO
ANSWER, otherwise OK
< Detection of dial tone from INMARSAT earth station.
# Last digit in the transmitted information to the Pager system.
Example:
Sends the information «1234» to the person pager at the :
number 966 08685
K_ Sending number from the password table
ATDK=SEMAFORUMg*=|
where SEMAFORUM is stored as
SEMAFORUM:1T4737011710 in the password table.
Ex. +P=SEMAFORUM: 14737011710
"Note that a specific telephone number only can be
stored once in the password table (associated with only
one password) if this number shail be dialled using
ATDK=<password>
> When this modifier is used the modem will go on-line on the
leased line connector (TX). This means that the modem can be
connected to two switch lines which can be selected with
command control.
'Fit might be necessary to change the strapping field J16,
using this function.
See the information about J16 in chapter 5.
3-12 LZTR104006 R1.00
Zat 14.4/14.4-7 and Zat 19.2/19.2-7