Ericsson ZAT 19.2 Operation Manual page 80

3, Command sets.
+PQO Password/Dialback
Commands: +PO0, +P01, +PO2
AT+PO0p*|
AT+PO1 6%]
AT+PO 2p .
Password/Dialback function OFF
(+PO may also be used)
Dialback enabled. Password required of all
users.
Dialback enabled. Password control is
optional
"Read more about the "Password/Dialback" in chapter 6
+PS Local password
Commands: +PS0, +PS1
AT+PS0g%|
AT+PS1 pial
Password not necessary
Calling an existing telephone number,
connected to a user logon in ihe password
table, ihe modem demands a password
The following message is transmitted when the corresponding
telephone number in the password table is detected:
ENTER PASSWORD FOR DIALLING PROTECTED TEL. NUMBER
= Enter the existing password, stored together with the
telephone number.
This mode may be used if there is more than one modem
operator, but not all are allowed to access the encryption mode.
3-42
LZTR104006 R1.00
ZAT 14.4/14.4-7 and Zat 19.2/19.2-7