Table of Contents
Advertisement
9.1.4
LAPM
HDLC based protocol with approximately 15% overspeed
compared to nominal speed.
9.1.5
Connection information
The modem will, depending on extended result code set-up,
report the connection information after the handshake and
protocol linkup as follows.
If the XO command is given no additional information is
presented.
If the X1, X2, X3 or X4 command is given, the +Q command
controls whether extra information is presented to the user :
:
'| Line speed is indicated
Ex. CONNECT 9600
Protocol presence is indicated by appending
/REL to the result message.
Ex. CONNECT 9600/REL
DTE speed is indicated by appending /dddd,
where dddd is DTE speed, This will be
appended both in protocol and non protocol
modes.
Ex. CONNECT 9600/REL/38400
As +Q2 but with protocol specification when
=
{there is a protocol connection.
Example:
| CONNECT 9600/REL/38400 LAPM. Legal
protocol specifications are: LAPM, MNP2,
MNP3, MNP4, MNP5 and V_.42bis.
Advertisement
Table of Contents
