Table of Contents
Advertisement
16.3.1
Permanent memory
All factory settings for the S-Registers are permanently stored
here. When power is connected for the first time, these values
are automatically transferred to the active memory and to the
userdefined memory where they remain although power is
disconnected again. If the content of the active memory has
been changed and you wish to reinstall the factory values, this
can be done by means of the &F.
16.4 Users, Settings
16.4.1
Active memory
The content of the active memory is always the valid
configuration profile when power is on and the modem is
operative. When the modem is in command state, the content
can be altered any time.
The content may be stored in the userdefined memory for later
use by means of the &W command. It can be brought back by
means of the Z command. Factory settings are retrieved by
means
of the Z command. Factory settings are retrieved by
means of the &F command.
16.4.2
Userdefined memory
in this memory, the user may store his own configuration profile.
It can be transferred to the active memory by means of the Z
command, of be replaced by means of the &W command. This
memory will keep it's content even if the power is turned off.
16-8
LZTR104006 R1.00
Zat 14.4/14.4-7 and 19.2/19.2-7
Advertisement
Table of Contents
