Connecting Interlock Cable To The Power Cabinet - ABB HVC-R 100/150 V2 Installation Manual

5.8. Connecting Interlock cable to the Power Cabinet

Prerequisites:

Tools: wire cutter, wire stripper pliers, screwdriver, ferrules, crimp pliers.
Make sure that the main switch of the power supply group for the product
is set to the OFF position. Do a voltage check to make sure that the
electrical power is disconnected from the system. Secure against
resetting.

Route the cable to the terminal blocks:
Route the Interlock cable to the terminal block (A). Refer to the figure for the preferred cable
route inside the cabinet.
Document: v0.1 / Document No.: TBA | Date: XX-08-2021
DANGER
Preferred cable route
HVC-R 100/150 V2 E-Bus Charger Installation Guide
Page 78 of 133