Service And Maintenance; About Service And Maintenance; Cleaning Of The Cabinet - ABB HVC-R 100/150 V2 Installation Manual

7. Service and Maintenance

7.1. About Service and Maintenance

Indication of Service and Maintenance phase on the planning diagram
E Service and Maintenance
Maintenance is done according to the maintenance schedule, which is outside of the
scope of this document.
Any service and maintenance work on the charger system has to be only
executed on powered-off device.
Make sure that the main switch of the power supply group for the product
is set to the OFF position. Do a voltage check to make sure that the
electrical power is disconnected from the system. Secure against
resetting.

7.2. Cleaning of the cabinet

The Power Cabinet and the Dual Depot Charge Box are powder coated. The coating must be
kept in good condition. Clean the Power Cabinet and the Dual Depot Charge Box three times
a year in the following way:

Remove rough dirt by spraying with low-pressure tap water.

Apply a neutral or weak alkaline cleaning solution and let it soak.

Remove dirt manually with a non-woven nylon hand pad.

Rinse thoroughly with tap water.

(Optionally) Apply wax on the front for extra protection and gloss.

Check the coating for any damage.
Document: v0.1 / Document No.: TBA | Date: XX-08-2021
HVC-R 100/150 V2 E-Bus Charger Installation Guide
DANGER
Page 117 of 133